Driver Interface Enclosure
The pDIM enclosure houses the race car's Driver Interface Module, the dashboard sitting directly in front of the steering wheel and the driver's main instrument while the car is running. My role on the chassis sub-team was to design the component that protects this circuit board from water and impact.
Most of the detail work was in how it mounts and seals. Extruded cuts at the centre and sides clear the chassis tubes with a 1 mm tolerance, and 25 mm plastic spacers sit between the mounting tabs and the enclosure tabs.
Inside, I included separators between the LEDs to prevent light bleeding from one indicator into its neighbour; the vertical LED strip is left open and covered by a diffuser instead, since there the blend is the point. The enclosure had to reach an IPX5 rating, surviving water jets from a 6.3 mm nozzle at any angle.
Tools
SolidWorks · Altium CoDesigner · Subversion (SVN) · 3-D Printing